Case 6401 - Page 31

Case Communications 6401 Rugged ADSL Router Manual – Rev 1.5
SECTION 5 – ADVANCED CONFIGURATION Page 5.10
DNS Server Configuration
.
Select DNS Server Interface from available WAN interfaces OR enter static DNS server
IP addresses for the system. In ATM mode, if only a single PVC with IPoA or static
IPoE protocol is configured, a Static DNS server IP addresses must be entered.
DNS Server Interfaces can have multiple WAN interfaces served as system DNS servers
but only one will be used according to the priority with the first being the highest and the
last one the lowest priority if the WAN interface is connected. Priority order can be
changed by removing all and adding them back in again
Select DNS Server Interface from available WAN interfaces
Selected DNS Server Interfaces
Available WAN Interfaces
pppoA


Use the following Static DNS IP address
Primary DNS Server
Enter IP Address of Primary Server
Secondary DNS Server
Enter IP Address of Secondary Server
Select ‘Next’ to see the WAN set up Summary
WAN Setup - Summary
Make sure that the settings below match the settings provided by your ISP.
Connection Type
PPPoA
NAT
Enabled
Full Cone NAT
Disabled
Firewall
Enabled
IGMP Multicast
Disabled
Quality of Service
Disabled
Click "Apply/Save" to have this interface to be effective. Click "Back"
to make any modifications.
Click "Apply/Save" to have this interface to be effective. Click "Back" to make any modifications.