EasyManua.ls Logo

Case 6401 - Page 36

Case 6401
107 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Case Communications 6401 Rugged ADSL Router Manual Rev 1.5
SECTION 5 ADVANCED CONFIGURATION Page 5.15
Select Next to go to the DNS Server configuration
Select DNS Server Interface from available WAN interfaces
Selected DNS Server
Interfaces
Available WAN
Interfaces
ppp0


Use the following Static DNS IP address
Primary DNS Server
Enter IP Address of Primary Server if not using
option above
Secondary DNS Server
Enter IP Address of Secondary Server if not
using the option above
Select next Wide Area Network (WAN) Service Setup
WAN Setup - Summary
Make sure that the settings below match the settings provided by your ISP.
Connection Type:
PPPoE
NAT:
Enabled
Full Cone NAT:
Disabled
Firewall:
Enabled
IGMP Multicast:
Disabled
Quality Of Service:
Enabled
Click "Apply/Save" to have this interface to be effective. Click "Back" to make any modifications.
Wide Area Network (WAN) Service Setup
Choose Add, Remove or Edit to configure a WAN service over a selected interface.
Interface
Description
Type
VLAN8021P
VLANMux ID
IGMP
Firewall
ppp0
ppp0e_eth0
PPPoE
N / A
N / A
Disabled
Enabled

Table of Contents

Related product manuals