OPERATION & MAINTENANCE MANUAL STE35SR
Keep Machine Clean
If water gets into the electrical system, there is a
hazard that it will cause malfunctions or
disoperation. Do not use water or steam to wash
the electrical system (sensors, alternators,
solenoid valves, connectors).
If inspection and maintenance is carried out
when the machine is still dirty with mud or oil,
there is a hazard that you will slip and fall, or that
dirt or mud will get into your eyes. Always keep
the machine clean.
When cleaning the engine around, the following two cannot be cleaned and splashed liquid,
otherwise it will cause damage of engine parts.
1 Generator; 2 Starting motor
Precautions of Standing up or Leaving from the Operator's Seat
Before standing up from the seat (for example, when adjusting the seat, etc.), lower the
working device to the ground completely. At the same time, move the lock lever to the locked
position, and then turn off the engine. If you accidentally touch the unlocked joystick, the
machine may move suddenly and cause a serious
personal accident.
When leaving the machine, you must lower the working
device and the bulldozer to the ground, place the lock
lever in the locked position, and stop the engine. In
addition, lock all equipment with a key. Take down the
key and put it in the specified position.
Use Handrails and Stairs Leaving Operator's Seat
To prevent personal injury caused by slipping or falling off the machine, always do as follows:
To ensure safety, always face the machine and maintain three-point contact (both feet and
one hand, or both hands and one foot) with the handrails and steps (including the track shoe)
to ensure that you support yourself.
Do not grip the control levers or lock lever when getting on or off the machine.
Never climb on the engine hood or cover that does not have anti-skid devices.
Before getting on or off the machine, check the handrails and steps (including the track shoe).
If there is any oil, grease, or mud on the handrails or steps (including the track shoe), wipe it
off immediately. Always keep these parts clean. Repair any damage and tighten any loose
bolts.
Do not get on or off the machine while holding tools in your hands.
To Next Page
Loading...