OPERATION & MAINTENANCE MANUAL STE35SR
Always fasten your seat belt.
Check that the movement of the machine matches the display on the control pattern card. If it
does not match, replace it immediately with the correct control pattern card.
Check the operation of the gauges and equipment, and check the operation of the bucket,
arm, boom, travel system, swing system, and steering system.
Check for any problem in the sound of the machine, vibration, heat, smell, or gauges; check
that whether there is leakage of oil or fuel or not.
If any problem is found, carry out repairs immediately.
Safety Rules for Changing Machine Directions
Before traveling, set the machine so that sprocket ①
is behind the operator's seat. If sprocket ① is in
front of the operator's seat, the machine is in the
opposite direction from the operation of the
lever(front and rear travel is reversed, left and right
steering is reversed). Be extremely careful when
operating the machine in this situation.
Before traveling, check again that there is no one
in the surrounding area, and that there are no
obstacles.
Before traveling, sound the speaker to warn
people in the area.
Always operate the machine only when seated.
Do not allow anyone apart from the operator to
ride on the machine.
If there is an area to the rear of the machine
which cannot be seen, position a signal person.
Take special care so as not to hit other machines
or people when turning or swinging the machine.
Check that the travel alarm (optional) works
properly.
Always be sure to carry out the above precautions
even when the machine is equipped with mirrors.
Safety Rules for Traveling
Do not operate the machine too quickly, suddenly
start, stop or turn.
When traveling on flat ground, keep the work
equipment 40 to 50cm high above the ground.
When traveling on rough ground, travel at low
speed and do not operate the steering suddenly.
There is danger that the machine may turn over.
The work equipment may hit the ground surface
To Next Page
Loading...