OPERATION & MAINTENANCE MANUAL STE35SR
and cause the machine to lose its balance, or
may damage the machine or structures in the
area.
Avoid traveling over obstacles when possible. If
the machine has to travel over an obstacle, keep
the work equipment close to the ground and
travel at low speed. Never travel over obstacles
which make the machine tilt strongly to one side.
When traveling or carrying out operations,
always keep a safe distance from people,
structures, or other machines to avoid coming
into contact with them.
When passing over bridges or structures, check first that the structure is strong enough to
support the weight of the machine. In addition, when walking on the highway, first ask the
relevant authorities to check and follow their instructions.
When operating in tunnels, under bridges, under electric wires, or other places where the
height is limited, operate slowly and be extremely careful not to let the work equipment hit
anything.
Do not let the machine or working device touch anything.
Traveling on Slopes
To prevent the machine from tipping over or slipping to
the side, always do as follows.
Keep the work equipment approx. 20 to 30 cm
above the ground. In case of emergency, lower
the work equipment to the ground immediately to
help stop the machine.
When traveling up slopes, set the driver's shed
facing uphill, when travel down slopes, set the
driver's shed facing downhill. Always check the
firmness of the ground under the front of the
machine when traveling.
When traveling up a steep slope, extend the work
equipment to the front to improve the balance,
keep the work equipment approximately 20 to 30
cm above the ground, and travel at low speed.
To Next Page
Loading...