OPERATION & MAINTENANCE MANUAL STE35SR
Speaker function-check
1. Turn the key switch to the ON position.
2. Confirm that the speaker will sound when the speaker
button on the right handle is pressed. If the speaker
does not work, please contact CFG dealer for repair.
2. Start switch
The switch is used to start or shut down the engine.
OFF position
The key can be inserted or removed. All switches of the
electrical system are closed and the engine is stopped.
ON position
Current flows in the charging and lamp circuits. When
the engine is running, keep the starter key in the ON
position.
START position
This is the engine start position. When starting the
engine, keep the key in this position. After the engine
starts, release the key immediately and it will
automatically return to the ON position.
HEAT (preheat) position（only for models with
manual preheating, this model has automatic
preheating）
When starting the engine in winter, you must first turn
the key to this position. The preheating time does not
exceed 15s, and the preheating will be automatically disconnected if it exceeds 15s. After
preheating, release the key immediately and it will automatically return to the OFF position.
3. Lock lever
When leaving the operator's seat, set the lock lever
securely to the LOCK position. If the lock lever is
not at the lock position, and the control levers are
touched by mistake, it may lead to serious
personal injury.
If the lock lever is not securely at the LOCK
position, the lock lever may be moved, it may lead
to serious accident or injury.
When pulling the lock lever up, be careful not to
touch the work equipment control lever.
When pushing the lock lever down, be careful not to touch the work equipment control lever.
This lever is a device to lock the work equipment, swing, travel, and attachment (if equipped)
control levers.
LOCK position: The engine can be safely started or the operation can be stopped.
FREE position: The excavator is allowed to operate normally.
Notice: This lock lever is of hydraulic lock type. Accordingly, when it is in the lock position, the
control levers or control pedals move but the machine does not move.
To Next Page
Loading...