135
Appendix II
CCD/Laser Scan Engine
MSI Disable
Check Digit Verification
Select one of the three calculation formulas to verify the
check digit. If the check digit is incorrect, the barcode will
not be accepted.
Single Modulo 10
Double Modulo 10
Modulo 11 & 10
Single Modulo
10
Check Digit
Transmission
Decide whether to include the check digit in the data being
transmitted.
Last digit not transmitted
Transmitted
Last 2 digits not transmitted
Transmitted
Length Qualification
Fixed length
Max/Min Length
1~127
Negative Barcode Enable
Plessey Disable
Convert to UK Plessey When applied, each occurrence of the character "A" in the
barcode data will be replaced by the character "X".
No
Transmit Check Digit Decide whether to include the two check digits in the data
being transmitted.
Yes
Telepen Disable
Original Telepen
(Numeric)
The original Telepen includes numeric characters. No
AIM Telepen (Full
ASCII)
AIM Telepen (Full ASCII) includes all the alphanumeric and
special characters.
Yes
GS1 Databar-14/Expanded Disable
GS1
Databar-14
Transmit
Code ID
Decide whether to include Code ID ("]e0") will be included
in the data being transmitted.
GS1 DataBar-14 is short for GS1 DataBar Omnidirectional.
This group consists of (1) GS1 DataBar Omnidirectional,
(2) GS1 DataBar Truncated, (3) GS1 DataBar Stacked, and
(4) GS1 DataBar Stacked Omnidirectional.
GS1
Databar
Expanded
Transmit
Code ID
Decide whether to include Code ID ("]e0") will be included
in the data being transmitted.
This group consists of (1) GS1 DataBar Expanded, and (2)
GS1 DataBar Expanded Stacked.
Yes
Transmit Application
ID
Decide whether to include the Application ID ("01") in the
data being transmitted.
Yes
Transmit Check Digit Decide whether to include the check digit in the data being
transmitted.
Yes
To Next Page
Loading...
Need help?
General
