5-16
Cisco 1240 Connected Grid Router Hardware Installation Guide
OL-26223-04
Chapter 5 Mounting the Router
Mounting Instructions
Install the Router onto the Mounting Bracket
This section describes how to attach the router to the mounting bracket. The mounting bracket is
installed on the mounting plate (included in the Cisco pole mount kit), which is installed on a supported
pole type. For more information, see the “Pole Mount Kit” section on page 5-2
The instructions for the procedures in this section refer to the mounting bracket kit contents shown in
Figure 5-2 and the bracket features described in Figure 5-11.
Note Refer to the “Install the Optional Security Panel” section on page 5-19 for details on how to install the
optional security panel on the bracket.
Figure 5-13 Router Installed in Mounting Bracket
Mounting Instructions
What You Need
• Mounting bracket and hardware included in the “Mounting Bracket Kit” section on page 5-4.
• Socket wrench that you supply.
To mount the router on the bracket, follow these steps and refer to Figure 5-14 and Figure 5-15:
Step 1 Assemble eight sets of bracket hardware (washer, split lock washer, and bolt) as shown in the “Assemble
Bracket Hardware” section on page 5-13.
Step 2 Attach one set of hinge bolt hardware to the mounting bracket connector shown in Figure 5-15 (1).
300614
To Next Page
Loading...
