Cisco 6509 - Catalyst Chassis Switch - Page 234

A-24
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Appendix A Power Supply Specifications
2500 W AC-Input and DC-Input Power Supplies
Branch circuit requirement (AC-input) Each chassis power supply should have its own
dedicated, fused-branch circuit:
• For North America—20 A
• For International—Circuits sized to local and
national codes
• All AC power supply inputs are fully isolated.
– Source AC can be out of phase between
multiple power supplies in the same chassis,
which means that PS1 can be operating from
phase A and PS2 can be operating from
phase B.
– Source AC can be out of phase between AC
inputs on power supplies that are equipped
with multiple AC inputs, which means that
power cord 1 can be plugged into phase A and
power cord 2 can be plugged into phase B.
AC-input frequency 50/60 Hz (nominal) (±3% for full range)
Power supply output capacity
• 1300 W maximum (100–120 VAC)
• 2500 W maximum (200–240 VAC)
• 2500 W maximum (–48 to –60 VDC)
System power dissipation 3520 W (total input power) or 3.6 KVA (high-line
operation)
DC-input voltage –48 VDC to –60 VDC continuous
DC-input current
• 80 A @ –40.5 VDC
• 70 A @ –48 VDC
• 55 A @ –60 VDC
Power supply output (AC supply)
• 100/120 VAC operation
– 15.5 A @ +3.3 V
– 5A @ +5V
– 10 A @ +12 V
– 27.5 A @ +42 V
• 200/240 VAC operation
– 15 A @ +3.3 V
– 5A @ +5V
– 10 A @ +12 V
– 55.5 A @ +42 V
Table A-11 2500 W Power Supply Specifications (continued)
Specification Description