Cisco 6509 - Catalyst Chassis Switch - Catalyst 6513 Switch

1-50
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Chapter 1 Product Overview
Catalyst 6513 Switch
Catalyst 6513 Switch
Table 1-19 lists the features of the Catalyst 6513 switch chassis. Table 1-20 lists the specifications of the
Catalyst 6513 switch chassis. Figure 1-13 shows a view of the Catalyst 6513 switch chassis.
Table 1-19 Catalyst 6513 Switch Features
Feature Description
Chassis
• Thirteen horizontal slots. Slots are numbered from (1) top to (13)
bottom.
Supervisor Engines
• Supports Supervisor Engine 2, Supervisor Engine 32, and Supervisor
Engine 720.
– Supervisor Engine 2 is installed in slot 1 and slot 2.
– Supervisor Engine 1A is not supported.
– Supervisor Engine 32 and Supervisor Engine 720 are installed in
slot 7 and slot 8.
– Supervisor Engine 32 and Supervisor Engine 720 require that you
install the high-speed fan tray. You must also install a 2500 W or
higher capacity power supply in the chassis to power the high-speed
fan tray.
– Supervisor Engine 720 has built-in switching fabric. Switch Fabric
Modules are not supported by Supervisor Engine 720 and cannot be
installed in the same chassis.
• The uplink ports are fully functional on all redundant supervisor engine
models when they are in standby mode.
Note Redundant supervisor engines must be configured identically.
Modules
• Supports up to 12 Catalyst 6500 series modules.
• WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric Modules must be
installed in slot 7 or slot 8.
• WS-X6748-SFP, WS-X6748-GE-TX, and WS-X6704-10GE modules
are not supported in slots 2–8; they are supported in slots 9–13.
– Slots 1–8 support a single fabric channel; slots 9–13 support dual
fabric channels.
• Some Catalyst 6500 series modules may:
– Not be supported
– Require that you install a Supervisor Engine 720
– Have chassis slot restrictions
– Require a specific software release level
Check your software release notes for specific information.