Contents
vii
Catalyst 6500 Series Switches Installation Guide
OL-5781-04
Installing the Cable Management System (Catalyst 6509-NEB-A Switch Only) 3-23
Replacing the Cable Guide 3-25
Establishing the System Ground 3-27
Required Tools and Parts 3-28
Connecting the System Ground 3-29
Installing the Power Supplies in the Switch Chassis 3-34
Attaching the Interface Cables 3-34
Connecting the Supervisor Engine Console Port 3-34
Connecting the Supervisor Engine Uplink Ports 3-36
Verifying Switch Chassis Installation 3-41
Online Diagnostics 3-42
CHAPTER
4 Removal and Replacement Procedures 4-1
Removing and Installing the AC-Input Power Supplies 4-2
Removing and Installing the 950 W and 1400 W AC-Input Power Supplies 4-2
Removing and Installing the 2700 W AC-Input Power Supply 4-6
Removing and Installing the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W, and 6000 W AC-Input
Power Supplies
4-9
Removing and Installing the DC-Input Power Supplies 4-13
Removing and Installing a 950 W DC-Input Power Supply 4-13
Removing and Installing a 1300 W or 2500 W DC-Input Power Supply 4-17
Removing and Installing the 2700 W DC-Input Power Supply 4-25
Removing and Installing a 4000 W DC-Input Power Supply 4-31
Removing and Installing the Power Entry Modules (PEMs) 4-51
Required Tools 4-52
Removing the AC-Input PEM 4-52
Installing the AC-Input PEM 4-53
Removing the DC-Input PEM 4-54
Installing the DC-Input PEM 4-56
Removing and Installing the Fan Assembly 4-57
Required Tools 4-57
Removing the Fan Assembly 4-57
Installing the Fan Assembly 4-65
Checking the Installation 4-65
Installing the Air Filter Assembly on a Catalyst 6509-NEB-A Switch (Optional) 4-66
To Next Page
Loading...
