Cisco 7975G - SIP Configuration Menu for SIP Phones; SIP General Configuration Menu

SIP Configuration Menu for SIP Phones
The SIP Configuration menu is available on SIP phones. This menu contains these submenus:
SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on a SIP
phone. The following table describes the options in this menu.
Table 17: SIP General Configuration Menu Options
To ChangeDescriptionOption
Display only. Cannot configure.Displays the CODEC to use when a call
is initiated. This value will always be set
to none.
Preferred CODEC
Display only. Cannot configure.Displays the configuration of the
out-of-band signaling (for tone detection
on the IP side of a gateway). The Cisco
Unified IP Phone (SIP) uses the AVT
tone method to support out of band
signaling. This value will always be set
to avt.
Out of Band
DTMF
Display only. Cannot configure.This value will always be set to Yes.Register with
Proxy
From Cisco Unified Communications
Manager Administration, choose Device >
Device Settings > SIP Profile.
Displays the amount of time, in seconds,
after which a registration request expires.
Register Expires
Display only. Cannot configure.Displays the text that is displayed on the
top right status line of the LCD on the
phone. This text is for end-user display
only and has no effect on caller
identification or messaging. This value
will always be set to null.
Phone Label
From Cisco Unified Communications
Manager Administration, choose Device >
Device Settings > SIP Profile.
This value is set to No by default.Enable VAD
From Cisco Unified Communications
Manager Administration, choose Device >
Device Settings > SIP Profile.
Displays the start Real-Time Transport
Protocol (RTP) range for media.
Start Media Port
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
87
Cisco Unified IP Phone Settings
SIP Configuration Menu for SIP Phones