Cisco 7975G - Unified Communications Manager Administration

•
Cisco Unified Communications Manager Administration
•
Bulk Administration Tool (BAT)
•
BAT and the Tool for Auto-Registered Phones Support (TAPS)
For general information about phone configuration in Cisco Unified Communications Manager, see the
“Cisco Unified IP Phones” chapter in the Cisco Unified Communications Manager System Guide.
Related Topics
Cisco Unified Communications Manager Phone Addition Methods, on page 37
Set Up Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G in Cisco Unified
Communications Manager Administration
The following steps provide an overview and checklist of configuration tasks for the Cisco Unified IP Phone
7975G, 7971G-GE, 7970G, 7965G, and 7945G in Cisco Unified Communications Manager Administration.
The steps present a suggested order to guide you through the phone configuration process. Some tasks are
optional, depending on your system and user needs. For detailed procedures and information, see the sources
in the steps.
Procedure
Step 1
Gather the following information about the phone:
a) Phone Model
b) MAC address
c) Physical location of the phone
d) Name or user ID of phone user
e) Device pool
f) Partition, calling search space, and location information
g) Number of lines and associated directory numbers (DNs) to assign to the phone
h) Cisco Unified Communications Manager user to associate with the phone
i) Phone usage information that affects phone button template, softkey template, phone features, IP Phone
services, or phone applications
Provides list of configuration requirements for phone setup.
Identifies preliminary configuration that you need to perform before you configure individual phones,
such as phone button templates or softkey templates.
See the Cisco Unified Communications Manager System Guide, “Cisco Unified IP Phones” chapter, and
Telephony Features Available for Cisco Unified IP Phone, on page 124.
Step 2
Customize phone button templates (if required).
Changes the number of line buttons, speed-dial buttons, Service URL buttons, or adds a Privacy button to
meet user needs.
You must specify a service URL with an IPv4 address.
See Cisco Unified Communications Manager Administration Guide, “Phone Button Template Configuration”
chapter, and Phone Button Templates, on page 150.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
24
Cisco Unified IP Phone
Cisco Unified IP Phone Setup in Cisco Unified Communications Manager