Cisco 7975G - Set Device Authentication Field; Set EAP-MD5 Shared Secret Field

Table 35: 802.1X Authentication Status Menu Options
To changeDescriptionOption
Display only. Cannot configure.Real-time progress of the 802.1X
authentication status. Displays one of the
following states:
•
Disabled: 802.1X is disabled and the
transaction was not attempted.
•
Disconnected: Physical link is down
or is disconnected.
•
Connecting: System is trying to
discover or acquire the authenticator.
•
Acquired: Authenticator has been
acquired. System is waiting for
authentication to begin.
•
Authenticating: Authentication is in
progress.
•
Authenticated: Authentication was
successful or implicit authentication
occurred due to timeouts.
•
Held: Authentication failed. System
is waiting before next attempt
(approximately 60 seconds).
802.1X Authentication
Status
Set Device Authentication Field
Procedure
Step 1
Choose Settings > Security Configuration > 802.1X Authentication > Device Authentication.
Step 2
Set the Device Authentication option to Enabled or Disabled.
Step 3
Press Save.
Set EAP-MD5 Shared Secret Field
See Cisco Unified IP Phone Security Problems, on page 222 for recovery of a deleted shared secret.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
118
Cisco Unified IP Phone Settings
802.1X Authentication and Status Menus