Cisco 7975G - Buttons and Hardware Identification

Buttons and Hardware Identification
The following table describes the buttons and hardware on the phones.
Table 1: Phone Buttons and Hardware
DescriptionItem
Depending on configuration, programmable buttons provide access to:
•
Phone lines (line buttons) and intercom lines
•
Speed-dial numbers (speed-dial buttons), including the Busy Lamp Field
(BLF) speed-dial feature
•
Web-based services (for example, a Personal Address Book button)
•
Call features (for example, a Privacy, Hold, or Transfer button)
Buttons illuminate to indicate status:
•
Green, steady: Active call or two-way intercom call
•
Green, flashing: Held call
•
Amber, steady: Privacy in use, one-way intercom call, Do Not Disturb
(DND) active, or logged into Hunt Group
•
Amber, flashing: Incoming call or reverting call
•
Red, steady: Remote line in use (shared line, BLF status or active Mobile
Connect call)
Programmable buttons
1
Enables you to adjust the angle of the phone base.Footstand button2
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
4
Cisco Unified IP Phone
Buttons and Hardware Identification