Cisco 7975G - Firmware Version Items; Expansion Modules Screen; Display Expansion Modules Screen

Procedure
Step 1
Press Settings.
Step 2
Select Status.
Step 3
Select Firmware Version.
Step 4
To exit the Firmware Version screen, press Exit.
Firmware Version Items
Table 45: Firmware Version Information
DescriptionItem
Load file running on the phoneLoad File
JAR file running on the phoneApp Load ID
Java Virtual Machine (JVM) running on the phoneJVM Load ID
Operating system running on the phoneOS Load ID
Ffactory-installed load running on the phoneBoot Load ID
Load running on the Expansion Modules, if connected to a SIP or SCCP
phone
Expansion Module 1
Expansion Module 2
Digital signal processor (DSP) software version usedDSP Load ID
Expansion Modules Screen
The Expansion Modules screen displays information about each Cisco Unified IP Phone Expansion Module
that is connected to the phone.
Expansion Module Items, on page 191 explains the information displays on this screen for each connected
expansion module. You can use this information to troubleshoot the expansion module, if necessary. In the
Expansion Modules screen, a statistic preceded by “A” applies to the first expansion module. A statistic
preceded by “B” applies to the second expansion module.
Display Expansion Modules Screen
To display the Expansion Modules screen, follow these steps:
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
190
Model Information, Status, and Statistics
Expansion Modules Screen