Cisco 7975G Software Guide

•
To add users from your corporate LDAP directory, choose System > LDAP > LDAP System from
Cisco Unified Communications Manager Administration.
After the Enable Synchronization from LDAP Server is enabled, you will not be able
to add additional users from Cisco Unified Communications Manager Administration.
Note
For more information on LDAP, see the Cisco Unified Communications Manager System Guide,
“Understanding the Directory”.
•
To add a user and a phone at the same time, choose User Management > User/Phone Add from Cisco
Unified Communications Manager.
User Options Web Page Management
From the User Options web page, users can customize and control several phone features and settings. For
more information about the User Options web pages, see the Cisco Unified IP Phone 7975G, 7971G-GE,
7970G, 7965G, and 7945G User Guide for Cisco Unified Communications Manager (SCCP and SIP).
User Access to User Options Web Pages
Before a user can access the User Options web pages, you must add the user to the standard Cisco Unified
Communications Manager end user group and associate the appropriate phone with the user.
Make sure to provide end users with the following information about the User Options web pages:
•
The URL required to access the application. This URL is:
http://<server_name:portnumber>/ccmuser/, where server_name is the host on which the web server
is installed.
•
A user ID and default password are needed to access the application.
These settings correspond to the values you entered when you added the user to Cisco Unified
Communications Manager.
For more information, see:
• Cisco Unified Communications Manager Administration Guide, “User Group Configuration” and “End
User Configuration” chapters
• Cisco Unified Communications Manager System Guide, “Roles and User Groups” chapter
Related Topics
Cisco Unified Communications Manager User Addition, on page 154
Add User to End User Group
To add the user to the standard Cisco Unified Communications Manager End User group, perform these steps:
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
155
Features, Templates, Services, and Users
User Options Web Page Management

Cisco 7975G Specifications

General

Handset type	Wired handset
Product type	IP Phone
Product color	Grey, Silver
Speakerphone	Yes
Voice codecs	G.711Mu, G.711a, G.722, G.729A, iLBC
Number of melodies	24
Aspect ratio	4:3
Display diagonal	5.6 \
Display resolution	320 x 240 pixels
Lines quantity	8 lines
Phonebook capacity	- entries
Number of VoIP accounts	-
Front camera	No
Security algorithms	128-bit AES
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Supported network protocols	DHCP, TFTP
Volume control	Digital
Headphone outputs	1
Ethernet LAN (RJ-45) ports	2
Number of handles included	1 pc(s)
AC adapter output voltage	48 V
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Certification	FCC

Weight and Dimensions

Depth	152.4 mm
Width	266.7 mm
Height	203.2 mm
Weight	1600 g