CHAPTER 5
Features, Templates, Services, and Users
•
Features, Templates, Services, and Users Overview, page 123
•
Telephony Features Available for Cisco Unified IP Phone, page 124
•
Product-Specific Parameters, page 148
•
Corporate and Personal Directories, page 149
•
Phone Button Templates, page 150
•
Softkey Templates, page 153
•
Services Setup, page 153
•
Enable Device Invoked Recording, page 154
•
Cisco Unified Communications Manager User Addition, page 154
•
User Options Web Page Management, page 155
•
EnergyWise Setup on Cisco Unified IP Phone, page 157
•
UCR 2008 Setup, page 160
Features, Templates, Services, and Users Overview
After you install Cisco Unified IP Phones in your network, configure their network settings, and add them to
Cisco Unified Communications Manager, you must use Cisco Unified Communications Manager Administration
to configure telephony features, optionally modify phone templates, set up services, and assign users.
This chapter provides an overview of these configuration and setup procedures. Cisco Unified Communications
Manager documentation provides detailed instructions for these procedures.
For suggestions about how to provide users with information about features, and what information to provide,
see Internal Support Web Site, on page 241.
For information about setting up phones in non-English environments, see International User Support, on
page 257.
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
123
To Next Page
Loading...
Need help?
General
Weight and Dimensions
