Cisco 7975G - Set up UCR 2008 in Phone Configuration Window

Table 40: UCR 2008 Parameter Location
ProcedureAdministration pathParameter
Set Up UCR 2008 in Common Phone Profile
Configuration Window, on page 162
Device > Device Settings >
Common Phone Profile
FIPS Mode
Set Up UCR 2008 in Enterprise Phone
Configuration Window, on page 162
System > Enterprise Phone
Configuration
Set Up UCR 2008 in Phone Configuration
Window, on page 161
Device > PhoneSSH Access
Set Up UCR 2008 in Common Phone Profile
Configuration Window, on page 162
Device > Device Settings >
Common Phone Profile
Set Up UCR 2008 in Phone Configuration
Window, on page 161
Control Web Page Access, on page 199
Device > PhoneWeb Access
Set Up UCR 2008 in Phone Configuration
Window, on page 161
Device > PhoneHTTPS Server
Set Up UCR 2008 in Enterprise Phone
Configuration Window, on page 162
System > Enterprise Phone
Configuration
Set Up UCR 2008 in Common Phone Profile
Configuration Window, on page 162
Device > Device Settings >
Common Phone Profile
80-bit SRTCP
Set Up UCR 2008 in Enterprise Phone
Configuration Window, on page 162
System > Enterprise Phone
Configuration
See Network Configuration Menu, on page
66.
Device > Device Settings >
Common Device
Configuration
IP Addressing Mode
See Network Configuration Menu, on page
66.
Device > Device Settings >
Common Device
Configuration
IP Addressing Mode
Preference for Signaling
Set Up UCR 2008 in Phone Configuration Window
Use this procedure to set the following parameters:
•
SSH Access
•
Web Access
•
HTTPS Server
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
161
Features, Templates, Services, and Users
Set Up UCR 2008 in Phone Configuration Window