To changeDescriptionOption
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Indicates the loudness setting for
the beep tone that the remote party
receives. The remote party is the
party who is on a call with the party
whose phone has the Recording
Tone option enabled.
Range: 0 percent to 100 percent. (0
percent is –66 dBM and 100
percent is –3 dBM.)
Default: 84 percent (–10 dBM)
See also Recording Tone in this
table.
Recording Tone
Remote Volume
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Indicates the length of time in
milliseconds that the beep tone
plays.
If the value you configure here is
less than one third the interval, then
this value overrides the default
provided by the Network Locale.
Range: 0 to 3000
For some Network
Locales that use a
complex cadence, this
setting applies only to the
first beep tone.
Note
See also Recording Tone in this
table.
Recording Tone
Duration
If Wideband Headset UI Control is enabled, you
or the user can use the phone and choose >
User Preferences > Audio Preferences >
Wideband Headset.
If Wideband Headset UI Control is disabled, from
Cisco Unified Communications Manager
Administration choose Device > Phone > Phone
Configuration to set this value.
If you allowed this option to be user
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
Note
Indicates whether wideband is
enabled or disabled for the headset.
Default: Disabled
Wideband Headset
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
98
Cisco Unified IP Phone Settings
Media Configuration Menu