Cisco 7975G - Page 124

Table 29: Network Configuration Menu Options
To changeDescriptionOption
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Used to optimize installation time for
phone firmware upgrades and offload the
WAN by storing images locally, which
negates the need to traverse the WAN
link for each phone upgrade.
You can set the Load Server to another
TFTP server IP address or name (other
than the TFTP Server 1 or TFTP Server
2) from which the phone firmware can be
retrieved for phone upgrades. When the
Load Server option is set, the phone
contacts the designated server for the
firmware upgrade.
The Load Server option allows
you to specify an alternate TFTP
server for phone upgrades only.
The phone continues to use TFTP
Server 1 or TFTP Server 2 to
obtain configuration files. The
Load Server option does not
provide management of the
process and of the files, such as
file transfer, compression, or
deletion.
Note
Load Server
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Indicates whether the phone supports the
Real-Time Control Protocol (RTCP).
Settings include:
•
Enabled
•
Disabled (default)
If this feature is disabled, several call
statistic values display as 0. For more
information, see the following sections:
•
Call Statistics Screen, on page 191
•
Streaming Statistics, on page 209
RTP Control Protocol
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
104
Cisco Unified IP Phone Settings
Network Configuration Menu