Cisco 7975G - Page 127

To changeDescriptionOption
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
Enables and disables Link Layer
Discovery Protocol (LLDP) on the PC
port. Use this setting to force the phone
to use a specific discovery protocol.
Settings include:
•
Enabled (default)
•
Disabled
LLDP: PC Port
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Enables and disables Link Layer
Discovery Protocol Media Endpoint
Discovery (LLDP-MED) on the switch
port. Use this setting to force the phone
to use a specific discovery protocol,
which should match the protocol
supported by the switch. Settings include:
•
Enabled (default)
•
Disabled
LLDP-MED: SW Port
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Identifies the asset ID assigned to the
phone for inventory management.
LLDP Asset ID
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Enables users to receive notifications of
incoming calls and answer or end calls
while they work in a wireless
environment.
Wireless Headset
Hookswitch Control
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
Advertises the phone power priority to
the switch, which enables the switch to
appropriately provide power to the phone.
Settings include:
•
Unknown (default)
•
Low
•
High
•
Critical
LLDP Power Priority
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > Common Device
Configuration.
Displays the IP addressing mode that is
available on the phone. IPv4 only, IPv6
only, or IPv4 and IPv6.
IP Addressing Mode
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
107
Cisco Unified IP Phone Settings
Network Configuration Menu