Cisco 7975G - Page 167

Configuration referenceDescriptionFeature
For more information, see UCR 2008 Setup,
on page 160.
The IP phones that use SCCP support Unified Capabilities
Requirements (UCR) 2008 by providing the following
functions:
•
Support for Federal Information Processing Standard
(FIPS) 104-2
•
Support for TVS IPv6
•
Support for 80-bit SRTCP Tagging
As an IP Phone administrator, some of these functions
require you to set up specific parameters in Cisco Unified
Communications Manager Administration.
UCR 2008
For more information, see:
•
Cisco Unified Communications
Manager Administration Guide,
“Conference Bridge Configuration”
chapter
•
Cisco Unified Communications
Manager System Guide, “Understanding
Video Telephony” chapter
Allows a user to select the video display mode for viewing
a video conference, depending on the modes configured
in the system.
Video Mode
(SCCP phones only)
For more information, see:
•
Cisco Unified Communications
Manager Administration Guide,
“Conference Bridge Configuration”
chapter
•
Cisco Unified Communications
Manager System Guide, “Understanding
Video Telephony” chapter
•
Cisco VT Advantage Administration
Guide, “Overview of Cisco VT
Advantage” chapter
Enables video support on the phone.Video Support
(SCCP phones only)
For more information, see:
•
Cisco Unified Communications
Manager Administration Guide, “Cisco
Voice-Mail Port Configuration” chapter
•
Cisco Unified Communications
Manager System Guide, “Voice Mail
Connectivity to Cisco
Unified Communications Manager”
chapter
Enables callers to leave messages if calls are unanswered.Voice Messaging System
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
147
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone