Cisco 7975G - Page 199

Possible explanation and actionDescriptionMessage
Power cycle the phone.The configuration file is too large for
the file system on the phone.
CFG TFTP Size Error
Obtain a new copy of the phone firmware
and place it in the TFTP directory. You
should only copy files into this directory
when the TFTP server software is shut
down, otherwise the files may be corrupted.
Downloaded software file is
corrupted.
Checksum Error
None. This message is informational only.
Neither the CTL file nor the ITL file was
installed on the phone previously.
For more information about the Trust List,
see the Cisco Unified Communications
Manager Security Guide.
CTL and ITL files are installed on
the phone.
CTL and ITL installed
None. This message is informational only.
The CTL file was not installed previously.
For more information about the CTL file,
see the Cisco Unified Communications
Manager Security Guide.
The CTL file is installed on the
phone.
CTL installed
•
Network is busy: The errors should
resolve themselves when the network
load reduces.
•
No network connectivity between the
DHCP server and the phone: Verify
the network connections.
•
DHCP server is down: Check
configuration of DHCP server.
•
Errors persist: Consider assigning a
static IP address. See Network
Configuration Menu, on page 66 for
details on assigning a static IP address.
DHCP server did not respond.DHCP timeout
You can enable 802.1X authentication by
using the Settings > Security
Configuration > 802.1X Authentication
option on the phone. For more information,
see 802.1X Authentication and Status
Menus, on page 116.
802.1X Authentication is disabled on
the phone.
Disabled
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
179
Model Information, Status, and Statistics
Status Messages Screen