Cisco 7975G - Page 85

Network Configuration menu optionDescriptionCategory
DHCPDynamic Host Configuration Protocol
(DHCP) automatically assigns IP address
to devices when you connect them to the
network. Cisco Unified IP Phones enable
DHCP by default.
DHCP settings
DHCP Address Released
Domain NameIf you do not use DHCP in your network,
you can make IP settings manually.
IP settings
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP Server 1If you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You can
also assign an alternative TFTP server to
use instead of the one assigned by DHCP.
TFTP settings for
TFTP IPv4 servers
Alternate TFTP
TFTP Server 2
IPv6 Network Settings
DHCPv6Dynamic Host Configuration Protocol
(DHCP) automatically assigns IP address
to phone when you connect them to the
network. Cisco Unified IP Phones enable
DHCP by default.
DHCP settings
DHCPv6 Address Released
Domain NameIf you do not use DHCP in your network,
you can make IP settings manually.
IP settings
IPv6 Address
IPv6 Prefix Length
IPv6 DNS Server 1-2
IPv6 TFTP Server 1If you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You can
also assign an alternative TFTP server to
use instead of the one that DHCP assigns.
TFTP settings for
TFTP IPv6 servers
(SCCP phones
only)
IPv6 Alternate TFTP
IPv6 TFTP Server 2
Related Topics
Display Settings Menu, on page 62
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
65
Cisco Unified IP Phone Settings
Phone Setup Options