Cisco ASR 9000 Series System Configuration Guide

PurposeCommand or Action
Creates or modifies a policy map that can be attached to one
or more interfaces to specify a service policy and enters the
policy map configuration mode.
policy-map [ type qos ] policy-name
Example:
RP/0/RSP0/CPU0:router(config)# policy-map
policy2
Step 5
Specifies the name of the class whose policy you want to
create or change.
class class-name
Example:
RP/0/RSP0/CPU0:router(config-pmap)# class
class2
Step 6
Sets the QoS group identifiers on IPv4 or MPLS packets.
set qos-group qos-group-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# set
qos-group 5
Step 7
Returns the router to policy map configuration mode.exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Step 8
Ends the policy map configuration.end-policy-map
Example:
RP/0/RSP0/CPU0:router(config-pmap)#
end-policy-map
Step 9
Configures an interface and enters the interface configuration
mode.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
bundle-ether 1
Step 10
Creates a multilink interface bundle with the specified
bundle ID.
bundle id bundle-id
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle id
1
Step 11
(Optional)
Configures the L2 transport offload for satellite.
l2transport
Example:
RP/0/RSP0/CPU0:router(config-if)# l2transport
Step 12
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
82
Configuring QoS on the Satellite System
Offloading Service-policy on Bundle Access Port

Cisco ASR 9000 Series Specifications

General

Brand	Cisco
Model	ASR 9000 Series
Category	Network Router
Language	English