Cisco ATA 192 Administration Guide

CHAPTER 5
Administration Settings
•
Management, page 95
•
Log, page 102
•
Factory Defaults, page 105
•
Firmware Upgrade , page 105
•
Configuration Management, page 106
•
Reboot, page 106
Management
Use the Management pages to manage web access to the ATA web page and to enable protocols for remote
configuration and network management.
Web Access Management
Use the Administration > Management > Web Access Management page to configure the settings for
access to the administration of the ATA.
Cisco ATA 192 Web Access Management Fields
Access to the Cisco ATA 192 web page is enabled by default. Admin Access allows you to manage the
configuration from a computer in your office network, and web access allows you to connect from a computer
on a different subnet or on the Internet.
To access the ATA web page, launch a web browser and enter the URL in the Address bar. The URL must
include the specified protocol, the WAN IP address of the ATA, and the specified port number. For example,
with the HTTPS protocol, a WAN IP address of 203.0.113.50, and port 80, you would enter:
https://203.0.113.50:80
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
95

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through