Cisco ATA 192 Administration Guide

Vertical Service Announcement Codes
Table 44: Vertical Service Announcement Codes
DescriptionField
Base number for service announcements.
Default setting: blank
Service Annc Base Number
Extension codes for service announcements.
Default setting: blank
Service Annc Extension Codes
Outbound Call Codec Selection Codes
Table 45: Outbound Call Codec Selection Codes
DescriptionField
Dial prefix to make G.711u the preferred codec for the call.
Default setting: *017110
Prefer G711u Code.
Dial prefix to make G.711u the only codec that can be used for the call.
Default setting: *027110
Force G711u Code.
Dial prefix to make G.711a the preferred codec for the call.
Default setting: *017111
Prefer G711a Code.
Dial prefix to make G.711a the only codec that can be used for the call.
Default setting: *027111
Force G711a Code.
Dial prefix to make G.726r32 the preferred codec for the call.
Default setting: *0172632
Prefer G726r32 Code.
Dial prefix to make G.726r32 the only codec that can be used for the
call.
Default setting: *0272632
Force G726r32 Code.
Dial prefix to make G.729a the preferred codec for the call.
Default setting: *01729
Prefer G729a Code.
Dial prefix to make G.729a the only codec that can be used for the call.
Default setting: *02729
Force G729a Code.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
69
Voice Settings Configuration
Vertical Service Announcement Codes

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through