DescriptionField
The maximum value to cap the exponential back-off
retry delay (which starts at Register Retry Intvl and
doubles on every REGISTER retry after a failure).
The retry interval is always at Register Retry Intvl
seconds after a failure. If this feature is enabled, Reg
Retry Random Delay is added on top of the
exponential back-off adjusted delay value.
Default setting: 0, which disables the exponential
backoff feature.
Reg Retry Intvl Cap
Response Status Code Handling
Table 29: Response Status Code Settings
DescriptionField
SIP response status code for the appropriate Special
Information Tone (SIT). Reorder or Busy tone is
played by default for all unsuccessful response status
code for SIT 1 RSC through SIT 4 RSC.
Default setting: blank
SIT1 RSC
SIP response status code to INVITE on which to play
the SIT2 Tone.
Default setting: blank
SIT2 RSC
SIP response status code to INVITE on which to play
the SIT3 Tone.
Default setting: blank
SIT3 RSC
SIP response status code to INVITE on which to play
the SIT4 Tone.
Default setting: blank
SIT4 RSC
SIP response code that retries a backup server for the
current request.
Default setting: blank
Try Backup RSC
Interval to wait before the ATA retries registration
after failing during the last registration.
Default setting: blank
Retry Reg RSC
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
42
Voice Settings Configuration
Response Status Code Handling
To Next Page
Loading...
Need help?
General
