Cisco ATA 192 Administration Guide

DescriptionField
The customization of ATA.Customization
System Status
Table 22: System Status Settings
DescriptionField
Current date and time of the system; for example,
10/3/2003 16:43:00.
Set the system time by using the Network Setup >
Time Settings page.
Current Time
Total time elapsed since the last reboot of the system;
for example, 25 days and 18:12:36.
Elapsed Time
Total number of RTP packets sent, including
redundant packets.
RTP Packets Sent
Total number of RTP bytes sent.RTP Bytes Sent
Total number of RTP packets received, including
redundant packets.
RTP Packets Recv
Total number of RTP bytes received.RTP Bytes Recv
Total number of SIP messages sent, including
retransmissions.
SIP Messages Sent
Total number of bytes of SIP messages sent, including
retransmissions.
SIP Bytes Sent
Total number of SIP messages received, including
retransmissions.
SIP Messages Recv
Total number of bytes of SIP messages received,
including retransmissions.
SIP Bytes Recv
The External IP address used for NAT mapping.External IP
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
34
Voice Settings Configuration
System Status

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through