Procedure
Step 1
Click Browse and select the location of the upgrade file that you downloaded.
Step 2
Click the Upgrade button to upgrade the firmware.
Configuration Management
Use the Administration > Config Management pages to backup and restore the configuration settings for
the ATA.
Backup Configuration
Use the Administration > Config Management > Backup Configuration page to back up the ATA
configuration settings to a file. You can then later restore these same settings to the ATA.
Click the Backup button to save the configuration information of the ATA. When the dialog box appears,
choose a location where you want to save the .cfg file.
Tip: Rename the file with a name that includes the date and time when you did the backup.
Restore Configuration
Use the Administration > Config Management > Restore Configuration page to restore the ATA
configuration settings from a previous backup. We recommend that you back up your current configuration
settings before you restore a configuration.
Procedure
Step 1
Click Browse to locate the .cfg file on your computer.
Step 2
Click Restore to restore the settings from the selected file.
Reboot
Use the Administration > Reboot page to power cycle the ATA from the ATA web page. Another way to
do it is by pressing the Reset > Reboot button.
Click the Reboot button to power cycle the ATA. When the warning message appears, read the information,
and then click OK to reboot the ATA, or click Cancel to abandon the operation. The ATA and any connected
devices will lose network connectivity during this operation.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
106
Administration Settings
Configuration Management
To Next Page
Loading...
Need help?
General
