DescriptionField
The ATA supports bell 202 and v.23 standards for
caller ID generation. Default setting: bell 202
Caller ID FSK Standard:
Select the method you want to use, Default, or
Sweden default. Default setting: Default.
Feature Invocation Method:
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for calls through the PHONE 1
and PHONE 2 ports.
Enter the settings as described. After making changes, click Submit to save your settings, or click Cancel to
redisplay the page with the saved settings.
In a configuration profile, the FXS parameters must include an appropriate numeral for identifying the
port receiving the setting.
Note
General
Table 47: General Settings
DescriptionField
To enable this line for service, select yes. Otherwise, select no.
Default setting: yes
Line Enable
Streaming Audio Server (SAS)
Table 48: Streaming Audio Server Settings
DescriptionField
To enable the use of the line as a streaming audio source, select yes.
Otherwise, select no. If enabled, the line cannot be used for outgoing
calls. Instead, it auto-answers incoming calls and streams audio RTP
packets to the caller.
Default setting: no
SAS Enable
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
72
Voice Settings Configuration
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
To Next Page
Loading...
Need help?
General
