DescriptionField
Set whether the SIP is the Broadsoft ALTC.
Options are: Yes or No.
Default setting: No
Broadsoft ALTC.
Call Feature Settings
Table 52: Call Feature Parameters
DescriptionField
Enables the ATA to perform an attended transfer operation by ending
the active call leg and performing a blind transfer of the other call leg.
If this feature is disabled, the ATA performs an attended transfer
operation by referring the other call leg to the active call leg, while
maintaining both call legs. To use this feature, select yes. Otherwise,
select no.
Default setting: no
Blind Attn-Xfer Enable
User ID or URL of the auto-answering streaming audio server. When
only a user ID is specified, the current or outbound proxy is contacted.
Music-on-hold is disabled if the MOH Server is not specified.
Default setting: blank
MOH Server
Makes the ATA perform a transfer when a conference call has ended.
Select yes or no from the drop-down menu.
Default setting: yes
Xfer When Hangup Conf
This feature supports external conference bridging for n-way conference
calls (n>2), instead of mixing audio locally. To use this feature, set this
parameter to that of the server's name. For example:
conf@mysefver.com:12345 or conf (which uses the Proxy value as the
domain).
Default setting: blank
Conference Bridge URL
Select the maximum number of conference call participants. The range
is 3 to 10.
Default setting: 3
Conference Bridge Ports
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
77
Voice Settings Configuration
Call Feature Settings
To Next Page
Loading...
Need help?
General
