Configuration Profile
Table 33: Configuration Profile Settings
DescriptionField
Controls all resync actions independently of firmware
upgrade actions. Set to yes to enable remote
provisioning.
Default setting: Yes
Provision Enable:
Triggers a resync after every reboot except for reboots
caused by parameter updates and firmware upgrades.
Default setting: Yes
Resync On Reset:
The maximum value for a random time interval that
the ATA waits before making its initial contact with
the provisioning server. This delay is effective only
on the initial configuration attempt following
power-on or reset. The delay is a pseudo-random
number between zero and this value.
This parameter is in units of 20 seconds; the default
value of 2 represents 40 seconds. This feature is
disabled when this parameter is set to zero.
This feature can be used to prevent an overload of the
provisioning server when many devices power-on
simultaneously.
Default setting: 2 (40 seconds)
Resync Random Delay:
The time of day when the device tries to resync. The
resync is performed each day. Used with the Resync
At Random Delay.
Default setting: blank
Resync At (HHmm):
Used with the Resync At (HHmm) setting, this
parameter sets a range of possible values for the
resync delay. The system randomly chooses a value
from this range and waits the specified number of
seconds before attempting to resync. This feature is
intended to prevent the network jam that would occur
if all resynchronizing devices began the resync at the
exact same time of day.
Default setting: 600
Resync At Random Delay:
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
49
Voice Settings Configuration
Configuration Profile
To Next Page
Loading...
Need help?
General
