Cisco ATA 192 Administration Guide

Port List (ATA 192 only)
DescriptionField
The name of the interface: WAN or LAN.Interface
The number of packets transmitted from this port.TX (pkts)
The number of packets received by this port.RX (pkts)
The status of the port, showing whether the port is connected to a device
or disconnected.
Status
Click this button to reset the count of TX and RX packets to zero.Clear TX & RX
Network Status
Use the Status > Network Status page to view information about the WAN interface (INTERNET port).
Table 80: Basic Interface Detail
DescriptionField
The status of the INTERNET (WAN) interface, showing whether the
port is connected or disconnected.
Link Status
The host name of the ATA.Host Name
The domain name of the ATA.Domain
Table 81: IPv4 Interface Detail
DescriptionField
The IPv4 address of the INTERNET (WAN) interface.IP Address
The subnet mask for the INTERNET (WAN) interface.Subnet Mask
The IPv4 address of the default gateway.Gateway
The method for setting the MTU: Auto or ManualMTU Type
The largest protocol data unit (in bytes) permitted for network
transmission
MTU Size
IPv4 addresses for up to three DNS servers that are used for name
resolution.
DNS 1-3 (if applicable)
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
109
Status and Statistics
Network Status

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through