For a deeper understanding of these fields, refer to Request for Comments (RFC) 3261.Note
SIP Parameters
Table 27: SIP Parameters Settings
DescriptionField
The maximum times a call can be forwarded. The
valid range is from 1 to 255.
Default setting: 70
Max Forward:
Number of times an invite can be redirected to avoid
an infinite loop.
Default setting: 5.
Max Redirection:
The maximum number of times (from 0 to 255) a
request may be challenged.
Default setting: 2
Max Auth:
The User-Agent header used in outbound requests. If
empty, the header is not included. Macro expansion
of $A to $D corresponding to GPP_A to GPP_D
allowed.
Default setting: $VERSION
SIP User Agent Name:
The server header used in responses to inbound
responses.
Default setting: $VERSION
SIP Server Name:
The User-Agent name to be used in a REGISTER
request. If this value is not specified, the SIP User
Agent Name parameter is also used for the
REGISTER request.
Default setting: Blank
SIP Reg User Agent Name:
Defines the SIP Reg message Sequence Number.
Default setting: Blank
SIP Reg Starting Sequence Number:
Accept-Language header used. There is no default;
this indicates that the ATA does not include this
header. If empty, the header is not included.
Default setting: Blank
SIP Accept Language:
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
37
Voice Settings Configuration
SIP Parameters
To Next Page
Loading...
Need help?
General
