Cisco ATA 192 Administration Guide

Call Forward Settings
Table 59: Call Forward Settings
DescriptionField
Forward number for Call Forward All Service.
Default setting: blank
Cfwd All Dest
Forward number for Call Forward Busy Service. Same as Cfwd All
Dest.
Default setting: blank
Cfwd Busy Dest
Forward number for Call Forward No Answer Service. Same as Cfwd
All Dest.
Default setting: blank
Cfwd No Ans Dest
Delay in sec before Call Forward No Answer triggers.
Default setting: 20
Cfwd No Ans Delay
Selective Call Forward Settings
Table 60: Selective Call Forward Settings
DescriptionField
Caller number pattern to trigger Call Forward Selective service. When
the caller’s phone number matches the entry, the call is forwarded to
the corresponding Cfwd Selective Destination (Cfwd Sel1-8 Dest).
• • Use ? to match any single digit.
• • Use * to match any number of digits.
Example: 1408*, 1512???1234
In the above example, a call is forwarded to the corresponding
destination if the caller ID either starts with 1408 or is an 11-digit
numbering starting with 1512 and ending with 1234.
Default setting: blank
Cfwd Sel1-8 Caller
The destination for the corresponding Call Forward Selective caller
pattern (Cfwd Sel1-8 Caller).
Default setting: blank
Cfwd Sel1-8 Dest
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
89
Voice Settings Configuration
Call Forward Settings

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through