Cisco ATA 192 Administration Guide

DescriptionField
The number of the last caller; this caller is actively forwarded to the
Cfwd Last Dest via the Call Forward Last service. For more information,
see Vertical Service Activation Codes, on page 63.
Default setting: blank
Cfwd Last Caller
The destination for the Cfwd Last Caller.Cfwd Last Dest
The number of the last caller; this caller is blocked via the Block Last
Caller Service. For more information, see Vertical Service Activation
Codes, on page 63.
Default setting: blank
Block Last Caller
The number of the last caller; this caller is accepted via the Accept Last
Caller Service. For more information, see Vertical Service Activation
Codes, on page 63.
Default setting: blank
Accept Last Caller
Speed Dial Settings
Table 61: Speed Dial Settings
DescriptionField
Target phone number (or URL) assigned to speed dial 2, 3, 4, 5, 6, 7,
8, or 9.
Default setting: blank
Speed Dial 2-9
Supplementary Service Settings
Table 62: Supplementary Service Settings
DescriptionField
Call Waiting on/off for all calls.
Default setting: yes
CW Setting
Setting Block Caller ID on/off for all calls.
Default setting: no
Block CID
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
90
Voice Settings Configuration
Speed Dial Settings

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through