Cisco ATA 192 Administration Guide

Basic Settings
Use the Network Setup > Basic Settings page to set up your basic network settings.
Table 4: Basic Settings
DescriptionField
The domain name, if specified by your ISP.
Otherwise, leave the field blank.
Domain Name
The name of the ATA. The default value is the model
number. Your ISP may specify a host name to use.
Host Name
Choose the stack mode for network; there are three
modes can be set: IPv4 only, Pv6 Only, or Dual.
Stack mode
Choose the SIP packet preference, either IPv4 or IPv6.Signaling Preference
Choose the RTP packet preference, either is IPv4 or
IPv6.
Media Preference
IPv4 Settings
Use the Network Setup > Basic Setup > IPv4 Settings page to set up your IPv4 connection.
Enter the settings as described in the table. After making changes, click Submit to save your settings, or click
Cancel to redisplay the page with the saved settings.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
15
Network Configuration
Basic Settings

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through