Cisco ATA 192 Administration Guide

DescriptionField
Display the LAN IPv6 address information.LAN IPv6 Address
Time Settings
Use the Network Setup > Basic Setup > Time Settings page to set the system time for the ATA. By default,
the system time is set automatically by using a Network Time Protocol (NTP) server. You can configure the
system time manually. In addition, you can use this page to specify your time zone, enable Daylight Saving
adjustments, and modify related settings.
After making changes, click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
User Manual
If you prefer to set the system manually, click User Manual and then enter the date and time.
Table 10: Time Settings
DescriptionField
Enter the date in the following order: four-digit year,
month, day.
Date
Enter the time in the following order: hour (from 1
to 24), minutes, and seconds.
Time
Time Zone
To use a time server to establish the time settings, select Time Zone. Then complete the fields in this section.
Table 11: Time Zone Settings
DescriptionField
Choose the time zone for the site where the ATA is
in operation. Default setting: (GMT-08:00) Pacific
Time (USA & Canada).
Time Zone.
Check the box if you want to automatically adjust the
time when Daylight Savings Time is in effect.
Otherwise, uncheck the box.
Adjust Clock for Daylight Saving Changes.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
24
Network Configuration
Time Settings

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through