DescriptionField
ReINVITE request Expires header value. If you enter
0, the Expires header is not included in the request.
Range: 0–(2
31
–1)
Default setting: 30
ReINVITE Expires
Minimum registration expiration time allowed from
the proxy in the Expires header or as a Contact header
parameter. If the proxy returns a value less than this
setting, the minimum value is used.
Default setting: 1
Reg Min Expires
Maximum registration expiration time allowed from
the proxy in the Min-Expires header. If the value is
larger than this setting, the maximum value is used.
Default setting: 7200
Reg Max Expires
Interval to wait before the ATA retries registration
after failing during the last registration.
Default setting: 30
Reg Retry Intvl
When registration fails with a SIP response code that
does not match Retry Reg RSC, the ATA waits for
the specified length of time before retrying. If this
interval is 0, the ATA stops trying. This value must
be larger than the Reg Retry Intvl value, which cannot
be 0.
Default setting: 1200
Reg Retry Long Intvl
Random delay range (in seconds) to add to Register
Retry Intvl when retrying REGISTER after a failure.
Default setting: 0 (disabled)
Reg Retry Random Delay
Random delay range (in seconds) to add to Register
Retry Long Intvl when retrying REGISTER after a
failure.
Default setting: 0 (disabled)
Reg Retry Long Random Delay
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
41
Voice Settings Configuration
SIP Timer Values
To Next Page
Loading...
Need help?
General
