Cisco ATA 192 Administration Guide

FunctionDigit Sequence
Enter a period for element repetition. The dial plan accepts zero or more
entries of the digit. For example, 01. allows users to enter 0, 01, 011,
0111, and so on.
. (period)
Use this format to indicate that certain dialed digits are replaced by
other characters when the sequence is transmitted. The dialed digits can
be zero or more characters.
EXAMPLE 1: <8:1650>xxxxxxx
When the user presses 8 followed by a seven digit number, the system
automatically replaces the dialed 8 with 1650. If the user dials 85550112,
the system transmits 16505550112.
EXAMPLE 2: <:1>xxxxxxxxxx
In this example, no digits are replaced. When the user enters a 10-digit
string of numbers, the number 1 is added at the beginning of the
sequence. If the user dials 9725550112, the system transmits
19725550112.
<dialed:substituted>
Enter a comma between digits to play an “outside line” dial tone after
a user-entered sequence.
EXAMPLE: 9, 1xxxxxxxxxx
An “outside line” dial tone is sounded after the user presses 9, and the
tone continues until the user presses 1.
, (comma)
Enter an exclamation point to prohibit a dial sequence pattern.
EXAMPLE: 1900xxxxxxx!
The system rejects any 11-digit sequence that begins with 1900.
! (exclamation point)
Enter an asterisk to allow the user to enter a 2-digit star code.*xx
Enter S0 to reduce the short inter-digit timer to 0 seconds, or enter L0
to reduce the long inter-digit timer to 0 seconds.
S0 or L0
Digit Sequence Examples
The following examples show digit sequences that you can enter in a dial plan.
In a complete dial plan entry, sequences are separated by a pipe character (|), and the entire set of sequences
is enclosed within parentheses.
EXAMPLE: ([1-8]xx | 9, xxxxxxx | 9, <:1>[2-9]xxxxxxxxx | 8, <:1212>xxxxxxx | 9, 1 [2-9] xxxxxxxxx | 9,
1 900 xxxxxxx ! | 9, 011xxxxxx. | 0 | [49]11 )
•
Extensions on your system
( [1-8]xx | 9, xxxxxxx | 9, <:1>[2-9]xxxxxxxxx | 8, <:1212>xxxxxxx | 9, 1 [2-9] xxxxxxxxx | 9, 1 900
xxxxxxx ! | 9, 011xxxxxx. | 0 | [49]11 )
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
128
Advanced Options for Phone Services
Digit Sequences

Cisco ATA 192 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Ethernet
Voice Protocol	SIP
Audio Codecs	G.711, G.726, G.729
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-20 to 60°C (-4 to 140°F)
Humidity	10 to 90% non-condensing
Compliance	FCC, CE, UL
Fax Support	T.38, G.711 pass-through