DescriptionField
Select Yes if you want all AVT tone packets encoded
for redundancy to have the marker bit set for each
DTMF event.
Select No to have the marker bit set only for the first
packet.
Default setting: Yes
Mark All AVT Packets:
Indicates the AVT Packet size according to value set
in ptime or fixed 10ms.
Default setting: ptime
AVT Packet Size:
The lowest TCP port number that can be used for SIP
sessions.
Default setting: 5060
SIP TCP Port Min:
The highest TCP port number that can be used for
SIP sessions.
Default setting: 5080
SIP TCP Port Max:
Enables or disables the Computer Telephone Interface
feature provided by some servers.
Default setting: no
CTI Enable:
Set this parameter to Yes to configure the phone to
handle NOTIFY sipfrag messages.
You can also configure this parameter in the
configuration file:
<Keep_Referee_When_REFER_Failed ua="na">Yes
</Keep_Referee_When_REFER_Failed>
Keep Referee When REFER Failed:
Provides the option to take the caller ID from
PAID-RPID-FROM,P-ASSERTEDIDENTITY,
REMOTE-PARTY-ID, or FROM header.
Default setting: PAID-RPID-FROM
Caller ID Header:
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
39
Voice Settings Configuration
SIP Parameters
To Next Page
Loading...
Need help?
General
