DescriptionField
Enable Attended Call Transfer Service. Three Way Conference is
required for Attended Transfer.
Default setting: yes
Attn Transfer Serv
Enable Unattended (Blind) Call Transfer Service.
Default setting: yes
Unattn Transfer Serv
Enable MWI Service. MWI is available only if a Voice Mail Service is
set-up in the deployment.
Default setting: yes
MWI Serv
Enable VMWI Service (FSK)
Default setting: yes
VMWI Serv
Enable Speed Dial Service.
Default setting: yes
Speed Dial Serv
Secure Call Service. If this feature is enabled, a user can make a secure
call by entering an activation code (*18 by default) before dialing the
target number. Then audio traffic in both directions is encrypted for the
duration of the call.
Default setting: yes
Star codes are set in Vertical Service Activation Codes. To enable secure
calling by default, without requiring a star code, set the user’s Secure
Call Setting to yes. See User 1 and User 2, on page 88.
Secure Call Serv
Enable Referral Service. See the Referral Services Codes parameter in
Vertical Service Activation Codes, on page 63 for more information.
Default setting: yes
Referral Serv
Enable Feature Dial Service. See the Feature Dial Services Codes
parameter in Vertical Service Activation Codes, on page 63 for more
information.
Default setting: yes
Feature Dial Serv
Enable Service Announcement Service.
Default setting: no
Service Announcement Serv
Use the Caller ID number as the caller name.
Default settings: yes
Reuse CID Number As Name
Enable Caller ID during conference call.
Default settings: yes
CONFCID Serv
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
83
Voice Settings Configuration
Supplementary Service Subscription
To Next Page
Loading...
Need help?
General
