Cisco CATALYST 2960 User Manual

Index
IN-7
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
using RCP A-17
using TFTP A-11
guidelines for creating and using A-9
guidelines for replacing and rolling back A-21
invalid combinations when copying A-5
limiting TFTP server access 30-17
obtaining with DHCP 3-8
password recovery disable considerations 9-5
replacing a running configuration A-19, A-20
rolling back a running configuration A-19, A-21
specifying the filename 3-18
system contact and location information 30-17
types and location A-10
uploading
preparing
A-11, A-13, A-16
reasons for A-9
using FTP A-15
using RCP A-18
using TFTP A-12
configuration logger 29-11
configuration logging 2-4
configuration replacement A-19
configuration rollback A-19, A-20
configuration settings, saving 3-15
configure terminal command 12-17
configuring 802.1x user distribution 10-57
configuring port-based authentication violation
modes
10-41
configuring small-frame arrival rate 23-5
conflicts, configuration 39-12
connections, secure remote 9-42
connectivity problems 39-14, 39-15, 39-17
consistency checks in VTP Version 2 14-5
console port, connecting to 2-10
control protocol, IP SLAs 32-4
corrupted software, recovery steps with Xmodem 39-2
CoS
in Layer 2 frames
33-2
override priority 15-6
trust priority 15-6
CoS input queue threshold map for QoS 33-16
CoS output queue threshold map for QoS 33-19
CoS-to-DSCP map for QoS 33-63
counters, clearing interface 12-41
CPU utilization, troubleshooting 39-28
crashinfo file 39-23
critical authentication, IEEE 802.1x 10-54
critical VLAN 10-24
critical voice VLAN
configuring
10-54
cross-stack EtherChannel
configuration guidelines
38-13
described 38-3
illustration 38-4
support for 1-8
cross-stack UplinkFast, STP
described
18-5
disabling 18-16
enabling 18-16
fast-convergence events 18-7
Fast Uplink Transition Protocol 18-6
normal-convergence events 18-7
support for 1-8
cryptographic software image
SSH
9-42
SSL 9-46
switch stack considerations 7-15
customjzeable web pages, web-based authentication 11-6
CWDM SFPs 1-24
D
DACL
See downloadable ACL
daylight saving time
5-7
debugging
enabling all system diagnostics
39-21
enabling for a specific feature 39-20

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)