Cisco CATALYST 2960

Index
IN-6
Catalyst 2960 and 2960-S Switches Software Configuration Guide, Release 15.0(1)SE
OL-26520-01
cluster standby group
automatic recovery
6-11
considerations 6-10
defined 6-2
requirements 6-3
virtual IP address 6-10
See also HSRP
CNS
1-6
Configuration Engine
configID, deviceID, hostname
4-3
configuration service 4-2
described 4-1
event service 4-3
embedded agents
described
4-5
enabling automated configuration 4-6
enabling configuration agent 4-9
enabling event agent 4-7
management functions 1-6
CoA Request Commands 9-23
Coarse Wave Division Multiplexer
See CWDM SFPs
command-line interface
See CLI
command modes
2-1
commands
abbreviating
2-3
no and default 2-4
commands, setting privilege levels 9-8
command switch
accessing
6-10
active (AC) 6-9
configuration conflicts 39-12
defined 6-2
passive (PC) 6-9
password privilege levels 6-16
priority 6-9
recovery
from command-switch failure
6-9, 39-8
from lost member connectivity 39-12
redundant 6-9
replacing
with another switch
39-11
with cluster member 39-9
requirements 6-3
standby (SC) 6-9
See also candidate switch, cluster standby group,
member switch, and standby command switch
community strings
configuring
6-13, 30-8
for cluster switches 30-4
in clusters 6-13
overview 30-4
SNMP 6-13
compatibility, feature 23-12
compatibility, software
See stacks, switch
config.text
3-18
configurable leave timer, IGMP 21-6
configuration, initial
defaults
1-16
Express Setup 1-1
configuration changes, logging 29-11
configuration conflicts, recovering from lost member
connectivity
39-12
configuration examples, network 1-18
configuration files
archiving
A-20
clearing the startup configuration A-19
creating using a text editor A-10
default name 3-18
deleting a stored configuration A-19
described A-8
downloading
automatically
3-18
preparing A-11, A-13, A-16
reasons for A-8
using FTP A-13