Chapter 1 Product Overview
10/100 and 10/100/1000 Ethernet Switching Modules
1-26
Catalyst 6500 Series Switch Module Installation Guide
78-15725-02
48-Port 10/100BASE-T Ethernet Switching Module
(WS-X6248A-TEL)
The 48-port 10/100BASE-T Ethernet switching module (WS-X6248A-TEL)
provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See
Figure 1-12.) The WS-X6248A-TEL Ethernet module has a larger buffer than the
WS-X6248-TEL Ethernet module. Four RJ-21 connectors (12 ports per
connector) use Category 3, Category 5, Category 5e, or Category 6 UTP or FTP
cable to connect to the network.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Figure 1-12 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248A-TEL)
The front panel LEDs are described in Table 1-6 on page 1-47.
24-Port 100BASE-FX Ethernet Switching Module
(WS-X6324-100FX-MM)
The 24-port 100BASE-FX switching module (WS-X6324-100FX-MM) provides
24 switched, 100-Mbps, full- or half-duplex ports. (See Figure 1-13.) The module
has 24 MT-RJ connectors for connection to the MMF cable.
Note This module is a Class 1 laser product. Refer to the Regulatory Compliance and
Safety Information for the Catalyst 6500 Series Switches for information on
working with lasers.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
18502
48 PORT
10/100 BASE-T
ETHERNET SWITCHING
MODULE
WS-X6248-RJ-TEL
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
13-24
1-12
25-36
37-48
To Next Page
Loading...
