Cisco Catalyst 6500 Series Installation Guide

Chapter 3 Installing the Module
What To Do After Installing Modules and Verifying Connectivity
3-22
Catalyst 6500 Series Switch Module Installation Guide
78-15725-02
Checking Connectivity
To check connectivity on any switching module port, perform these tasks:
For example, to ping a host named server1, enter this command:
Console> ping server1
server1 is alive
Console>
What To Do After Installing Modules and Verifying
Connectivity
After you verify the supervisor engine or switching module installation and check
connectivity, you must configure the module. For complete information on
configuring the supervisor engine and all modules, refer to the Catalyst 6500
Series Switch Software Configuration Guide or the Catalyst 6500 Series Switch
Cisco IOS Software Configuration Guide. For information on all Catalyst 6500
series switch commands, refer to the Catalyst 6500 Series Switch Command
Reference or the Catalyst 6500 Series Switch Cisco IOS Command Reference
publications.
Task Command
• Ping a host. ping host
• If the host is unresponsive, check the
IP address of the switch and default IP
route, if appropriate.
show interface
show ip route

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English