Cisco ONS 15454 - NTP-G328 Adding, Modifying, or Deleting ANS Parameters

Provisioning or higherSecurity Level
Procedure
Step 1 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Step 2 From the Selector area, select the PSM slot. If the default parameters are present, continue with Step 3. If not,
click Add to add the Channel LOS Threshold and VOA Attenuation parameters. To add the ANS parameters,
see the DLP-G541 Adding an ANS Parameter, on page 14 for instructions.
Step 3 Click the value of the ANS parameter that you want to modify and enter the new value specified in the
following table. To modify the ANS parameters, see the DLP-G681 Modifying an ANS Parameter, on page
15 for instructions.
Table 3: Values for the ANS Parameters (PSM)
ValueANS ParameterPort
3.0 dBVOA AttenuationSlot 14(PSM).Port W-RX
15.0 dBChannel LOS ThresholdSlot 14(PSM).Port W-RX
10.0 dBVOA AttenuationSlot 14(PSM).Port P-RX
20.0 dBChannel LOS ThresholdSlot 14(PSM).Port P-RX
Step 4 Click Apply.
Step 5 Click the Provisioning > WDM-ANS > Port Status tabs.
Step 6 Click Launch ANS.
Step 7 In the Apply Launch ANS dialog box, click Yes.
Step 8 In the Launch ANS confirmation dialog box, click OK.
Step 9 In node view (single-shelf mode) or multishelf view (multishelf mode), click the Provisioning > WDM-ANS
> Provisioning tabs.
Step 10 Verify the following in the Results column:
• Success - Changed —The parameter has been successfully changed with the ports in IS.
Step 11 Verify that the Set By column displays t he value “ANS” or “APC” as the application that sets the
ANS parameter.
Step 12 Return to your originating procedure (NTP).
NTP-G328 Adding, Modifying, or Deleting ANS Parameters
This procedure allows you to add, modify, or delete
ANS parameters for a DWDM node.
Purpose
Turning Up a Node
13
Turning Up a Node
NTP-G328 Adding, Modifying, or Deleting ANS Parameters