Required if you want to implement SNMPv3 on your
network.
Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 tabs.
Step 2 Complete the following tasks as required:
• DLP-G496 Creating an SNMPv3 User, on page 68
• DLP-G498 Create Group Access , on page 69
• DLP-G497 Create MIB Views , on page 69
• DLP-G501 Creating Notification Filters, on page 72
• DLP-G499 Configure SNMPv3 Trap Destination , on page 70. When you configure an SNMPv3 trap
destination, use the IP address of the NMS, and the port number on which the NMS is listening for traps.
Stop. You have completed this procedure.
NTP-G212 Manually Provisioning a GNE/ENE to Manage an ENE
using SNMPv3
This procedure describes how to manually configure
a GNE/ENE to allow the NMS to manage an ENE
using SNMPv3.
Purpose
NoneTools/Equipment
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Prerequisite Procedures
Required if you want to implement SNMPv3 on your
network.
Required/As Needed
Onsite or remoteOnsite/Remote
Provisioning or higherSecurity Level
Turning Up a Node
64
Turning Up a Node
NTP-G212 Manually Provisioning a GNE/ENE to Manage an ENE using SNMPv3
To Next Page
Loading...
